Re: Teacup on Sanginololu under Win 7

Attempting to use a Pro Micro to burn the bootloader to the Sanguinololu gives me the following:


Arduino: 1.6.4 (Windows 7), Board: "Sanguino, ATmega1284 or ATmega1284P (16 MHz)"

C:\Program Files (x86)\Arduino\hardware\tools\avr/bin/avrdude -CC:\Program Files (x86)\Arduino\hardware\tools\avr/etc/avrdude.conf -v -patmega1284p -cstk500v1 -PCOM11 -e -Ulock:w:0x3F:m -Uefuse:w:0xFD:m -Uhfuse:w:0xDE:m -Ulfuse:w:0xFF:m



avrdude: Version 6.0.1, compiled on Apr 15 2015 at 19:59:58

Copyright (c) 2000-2005 Brian Dean, [www.bdmicro.com]

Copyright (c) 2007-2009 Joerg Wunsch



System wide configuration file is "C:\Program Files (x86)\Arduino\hardware\tools\avr/etc/avrdude.conf"



Using Port : COM11

Using Programmer : stk500v1

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x3f

avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x3f

avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x3f

avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x3f

avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x3f

avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x3f

avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x3f

avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x3f

avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x3f

avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x3f



avrdude done. Thank you.



Error while burning bootloader.